ZM6605 Domestic Air Conditioner Simulator Teaching Education Equipment For School Lab Compressor Training Equipment Simple air conditioning systemCompressor Trainer/Training Equipment
Ventilation duct, cross section 250x250mm
Selectable expansion element, using solenoid valves
Expansion valve and capillary tubes 1m
Radial fan with regulating fin
Laminar evaporator with drip tray
Compressor: 1/2 HP
Condenser: Air cooled.
Evaporation chamber, damper.
Size (Length, Width, Height): 1100x720x490mm
Weight: 80kg
Must have fault insertion and simulation and allows drawing the P-I Diagram via 1.26
User manual in Spanish with theory and practices for instructor and student
Size: 1100x720x490mm
Freezer main controller
- Adopted 32-bit high-performance ARM processor
- Built-in USB port for PC connection
- Up to 16 temperature modules can be interlocked
- Built-in RS-485 communication terminal for multipoint communication
- The RS-485 communication circuit must be designed as an insulation structure to improve noise immunity.
- 12-bit AD input for pressure and humidity sensor interlocked 16Ch
- Built-in 16-channel digital input for function control.
- 16 built-in LEDs to verify the output status inside the PCB
- Built-in 16 external LEDs to verify the output status
- Up to 16 relay output channels (8 basic channels, 8 optional channels)
- The relay for the output must have a rating of 10 A or higher.
- The SMPS and DCDC converter must be integrated and designed with an external signal and an insulation structure.
- Power source: AC86 ~ 264V, 50 / 60Hz free voltage
- Within the size of PCB 250X140
It must contain the elements cited below as:
Compressor: 1 / 2HP, single phase 220V, Control box.
Condenser: Air cooled.
Evaporator: Pin, Tube Type.
Accumulator: 1 / 2HP
Receiver Tank: 1 / 2HP
Expansion Valve: Manual, welded.
Electronic valve to operate: 3/8 ’’ with clamp or welded.
Filter Dryer: 3/8 ’’ with clamp or welded
Pressure gauge: High Pressure, Low Pressure.
Filling nipple, attached to a nipple to fill
Acrylic visor: with clamp or welded
Duct: PC 250x250
Fan: 220V, speed controller included
Pin heater: 1Kw
Wind Pressure: 220V Pitot Tube
Temperature Sensor: 9 pieces
Liquid Receiver, Accumulator
Refrigerator temperature module
- Built-in 4Digit FND with good visibility
- Up to 16 temperature modules can be interlocked
- Built-in RS-485 communication terminal for multipoint communication
- RTD type temperature sensor input
- Accuracy within ± 0.2 degrees
- Built-in 10A rating relay
- Built-in 4-bit rotary switch for address configuration
- Using a 10 A output relay
- Power source: DC24V
- Front PCB size within 70X50